Freedom-designs Freedom SP3 Manuel d'utilisateur télécharger pdf (Page 18)

Freedom Designs, Inc. SP3

WARNING:

2. Check to make sure push handles grips will not rotate or slip off.

If you fail to heed these warnings, damage to your chair, a fall, tip-over or loss of

control may occur and cause severe injury to the rider or others.

Quick Release Axles

1. Do not use this chair UNLESS you are sure that both quick release axles are

locked. An unlocked axle may come off during use and cause a fall.

2. An axle is not locked until the quick release button pops out fully. An

unlocked axle may come off during use, resulting in a fall, tip-over or loss of

control and cause injury to the rider or others.

If you fail to heed these warnings, damage to your chair, a fall, tip-over or loss of

control may occur and cause severe injury to the rider or others.

Rear Wheels

A change in setup of the rear wheels will affect the center of balance of your chair.

1. The farther you move the rear axles FORWARD, the more likely it is that your

chair will tip over backward.

2. Consult your doctor, nurse or therapist to find the best rear axle setup for your

chair.

3. Adjust the rear wheel locks after you make any change to the rear axles.

a. If you fail to do so, the locks may not work.

b. Make sure lock arms embed in tires at least 1/4” when locked.

If you fail to heed these warnings, damage to your chair, a fall, tip-over or loss of

control may occur and cause severe injury to the rider or others.

Wheel Locks/Hub Locks

Rear/front wheel locks, including hub locks, are NOT designed to slow or stop a

moving wheelchair. Use the rear/front wheel locks only to keep the rear/front

wheels from rolling when your chair is at a complete stop.

1. NEVER use rear/front wheel locks to try to slow or stop your chair when it is

moving. Doing so may cause you to veer out of control.

2. To keep the rear/front wheels from rolling, always set both rear/front wheel

locks when you transfer to or from your chair.

3. Low pressure in a rear/front tire may cause the wheel lock on that side to slip

and may allow the wheel to turn when you do not expect it.

4. Make sure lock arms embed in tires at least 1/4” when locked. If you fail to do

so, the locks may not work.

If you fail to heed these warnings, damage to your chair, a fall, tip-over or loss of

control may occur and cause severe injury to the rider or others.

Modified Seating System

Use of a seating system not approved by Freedom Designs, Inc., may alter the

center of balance of this chair. This may cause the chair to tip over.

1. Do not change the seating system of your chair UNLESS you consult your

authorized Freedom Designs, Inc. supplier first.

2. Use of a seating system not approved by Freedom Designs, Inc. may affect the

folding mechanism of this chair.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Freedom-designs Freedom SP3 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Santé et hygiène Freedom-designs Freedom SP3